I have had a mid 2010 MacBook Pro for a while. It works well, but it is sluggish. Rather than invest in a new MacBook, I chose to make a fairly quick and simple upgrade.
It already has 8GB of RAM, so I decided to replace the hard disk with an SSD. I purchased a new SanDisk 250 GB SSD when I found it on sale a few weeks ago.
I had purchased a 2.5″ external drive case from OWC a while back. I used the interface contained in the drive enclosure to attach the SSD to my MacBook. After formatting the SSD as an APFS drive, I used Carbon Copy Cloner to ‘clone’ (make an exact copy) my boot drive to the SSD. Fortunately for me, this didn’t take too long as the 320 GB hard disk was less than half full – less than 4 hours.
Once the drive had been cloned, I rebooted my Mac selecting the SSD as the boot device (depressed the Option keep when the Mac chimed on reboot and selected the new SSD as the boot drive). I verified that the SSD was working as it should, then shut down my MacBook.
I removed the screws on the back cover, then removed the screws holding the hard drive bracket. I was then faced with removing the Torx screws that held in the drive. Unfortunately, I didn’t have a T6 Torx screwdriver available. That necessitated a trip to a nearby Lowe’s. There I picked up a “Kobalt 14-in-1 Precision Driver Set” for about $10 that included the needed T6 head (second from top on left in the photo above). Equipped with that, I easily removed the screws holding the drive in place, then gently disconnected the SATA ribbon cable from the drive. With nothing holding the drive in place I was able to remove it from my MacBook.
I attached the SATA cable to my SSD, placed it into position in the Mac, then refastened the bracket in place. I closed up my Mac, then fired it up. As expected it booted in a fraction of the time previously required with the hard disk. The operation of macOS is now much snappier. Apps boot faster. Alfred works quicker. For the investment of less than $100, I have a drastically improved MacBook.
As a final step, I mounted the old hard drive in the external chassis. I haven’t reformatted it yet, but if there are no hiccups in the operation of my MacBook I will soon reformat that drive as APFS and will have an external 320GB drive to use.
If you have an older Mac, this is a relatively easy and low-cost way to bring new life to it!
See my other Mac and OS X articles